IT/Software/Virtualization/QEMU/OSX-KVM: Difference between revisions
Access restrictions were established for this page. If you see this message, you have no access to this page.
mNo edit summary |
Walttheboss (talk | contribs) No edit summary |
||
| Line 11: | Line 11: | ||
**sudo ip link set dev virbr0 up | **sudo ip link set dev virbr0 up | ||
**sudo ip link set dev tap0 master virbr0 | **sudo ip link set dev tap0 master virbr0 | ||
* Or you can run them all at one time by running from withing the .qemu directory | |||
<code>./qemuNetworking.sh </code> | |||
Revision as of 10:36, 21 February 2020
Source
https://github.com/kholia/OSX-KVM
MSGCNX MacOS Install
- All the files are located at ~/.qemu/OSX-KVM/
- Inside that folder is a script called boot-macOS-NG.sh which can be run to boot the VM.
- If you need networking in the VM you can run the following four commands on the host to add the network interface:
- sudo ip tuntap add dev tap0 mode tap
- sudo ip link set tap0 up promisc on
- sudo ip link set dev virbr0 up
- sudo ip link set dev tap0 master virbr0
- Or you can run them all at one time by running from withing the .qemu directory
./qemuNetworking.sh