IT/Software/Virtualization/QEMU/OSX-KVM: Difference between revisions
Access restrictions were established for this page. If you see this message, you have no access to this page.
mNo edit summary |
mNo edit summary |
||
| Line 6: | Line 6: | ||
*All the files are located at ~/.qemu/OSX-KVM/ | *All the files are located at ~/.qemu/OSX-KVM/ | ||
*Inside that folder is a script called boot-macOS-NG.sh which can be run to boot the VM. | *Inside that folder is a script called boot-macOS-NG.sh which can be run to boot the VM. | ||
*If you need networking in the VM you can run the following four commands to add the network interface: | *If you need networking in the VM you can run the following four commands on the host to add the network interface: | ||
**sudo ip tuntap add dev tap0 mode tap | **sudo ip tuntap add dev tap0 mode tap | ||
**sudo ip link set tap0 up promisc on | **sudo ip link set tap0 up promisc on | ||
**sudo ip link set dev virbr0 up | **sudo ip link set dev virbr0 up | ||
**sudo ip link set dev tap0 master virbr0 | **sudo ip link set dev tap0 master virbr0 | ||
Revision as of 17:06, 20 February 2020
Source
https://github.com/kholia/OSX-KVM
MSGCNX MacOS Install
- All the files are located at ~/.qemu/OSX-KVM/
- Inside that folder is a script called boot-macOS-NG.sh which can be run to boot the VM.
- If you need networking in the VM you can run the following four commands on the host to add the network interface:
- sudo ip tuntap add dev tap0 mode tap
- sudo ip link set tap0 up promisc on
- sudo ip link set dev virbr0 up
- sudo ip link set dev tap0 master virbr0