IT/Software/Command Line Applications/iperf3: Difference between revisions
Access restrictions were established for this page. If you see this message, you have no access to this page.
Walttheboss (talk | contribs) |
Walttheboss (talk | contribs) No edit summary |
||
| Line 29: | Line 29: | ||
-t 5 will only check five times. Usually enough | -t 5 will only check five times. Usually enough | ||
*For example: | |||
For example: | |||
*<code>iperf3 -c 10.243.204.189 -V -t 5</code> | *<code>iperf3 -c 10.243.204.189 -V -t 5</code> | ||
Revision as of 06:07, 25 May 2020
General
Install
sudo apt install iperf3
Usage
Server
This is the computer that will listen for requests for speed checks.
On the server you need to start listening
iperf3 -s
Server Options
-1 is great as it allows for one check from a remote client and then exits the program
Client
This is the computer that will try to dial into the server to test their communication speed
On the client you need to send the request
iperf3 -c ipAddressOfServer
NOTE: If the server is on a dynamic ip and or behind a router that does not have the port forwarded then you will need zerotier setup to get to the listening computer.
Client Options
-V tell you more
-t 5 will only check five times. Usually enough
- For example:
iperf3 -c 10.243.204.189 -V -t 5