IT/Software/Command Line Applications/iperf3: Difference between revisions
Walttheboss (talk | contribs) (→Server) |
Walttheboss (talk | contribs) (→Server) |
||
| Line 10: | Line 10: | ||
On the server you need to start listening. | On the server you need to start listening. | ||
<code>iperf3 -s</code> | |||
Don't forget that if UFW is up and only allowing 80, 443, and 22 it won't work. | Don't forget that if UFW is up and only allowing 80, 443, and 22 it won't work. | ||
| Line 17: | Line 19: | ||
<code>sudo ufw allow 5201 && iperf3 -s -1 && sudo ufw deny 5201 && sudo ufw reload</code> | <code>sudo ufw allow 5201 && iperf3 -s -1 && sudo ufw deny 5201 && sudo ufw reload</code> | ||
=====Server Options===== | =====Server Options===== | ||
Latest revision as of 05:02, 28 May 2020
General
Install
sudo apt install iperf3
Usage
Server
This is the computer that will listen for requests for speed checks.
On the server you need to start listening.
iperf3 -s
Don't forget that if UFW is up and only allowing 80, 443, and 22 it won't work.
You will need to:
sudo ufw allow 5201 && iperf3 -s -1 && sudo ufw deny 5201 && sudo ufw reload
Server Options
-1 is great as it allows for one check from a remote client and then exits the program
Client
This is the computer that will try to dial into the server to test their communication speed
On the client you need to send the request
iperf3 -c ipAddressOfServer
NOTE: If the server is on a dynamic ip and or behind a router that does not have the port forwarded then you will need zerotier setup to get to the listening computer.
Client Options
-V tell you more
-t 5 will only check five times. Usually enough
-f M will report in Megabytes. For me still a bit more readable.
For example:
iperf3 -c 10.243.204.189 -V -t 5 -f M