Arduino/DC Motors
< Arduino
Access restrictions were established for this page. If you see this message, you have no access to this page.
Basics
Driving them.
On and Off (Transistor)
This is called bang-bang control. You either have full voltage or 0 voltage.
Since the Arduino can only supply a few hundred mA it is best to power them from an outside source.
Pulse Width Modulation (PWM (Transistor))
This feature is built into thje arduino The pins are labeled with a wavy symbol
On the UNO 3, 5, 6, 9, 10, and 11 have PWM capability.
All you are doing is switching the power on and off to simulate a lower voltage.
PWM through transistor
Dedicated Board